MMA7660 3 Axis Accelerometer Breakout Assembly

Assembled and tested in the USA. Fully assembled and tested. This is a breakout board developed for the Freescale MMA7660FC 3-axis G sensor ( accelerometer ) This board is setup to be used in a standard 0.1" breadboard or proto-board.

Breakout Board Features:

* 0.1" spaced pins in a 2 row by 4 pin configuration , rows are spaced 0.6"

* Independent power for DVDD and AVDD with 0.1uF bypass capacitors mounted directly below the IC.

* Low Voltage Operation: 2.4 V – 3.6 V

* 0805 resistor pads for SDA and SCL pull-up to DVDD, allows flexibility for I2C bus pull-up location. You can use internal pull-ups from your micro-controller, or pull-ups from another location on the I2C bus, or populate the breakout board resistors (two 4.7k Ohm 0805 resistor included with each board)

For detailed product information and code example downloads please consult the product forums section of this website. http://www.madscientisthut.com/forum_php/viewtopic.php?f=13&t=5